Randeez 2012 Budget Yukon Denali Build (stick on hood scoops galore)
- Thread starter randeez
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
iamdub
Full Access Member
How close are the two in length?
pwtr02ss
Full Access Member
OP
OP
randeez
Full Access Member
pwtr02ss
Full Access Member
That's beautiful. Looks sooo much better than before
OP
OP
randeez
Full Access Member
quality, not quantity
OP
OP
randeez
Full Access Member
not very...but as far as fluid dynamics is concerned the extra 180 on the passenger side should "lengthen" that side
OP
OP
randeez
Full Access Member
i also wanted to have the flange angle slightly up to hold the turbo, but the angle of the pipes just ran it into the ac compressor and crank pulley. and it wouldve made the turbo height a lot higher so its very near level and just slightly tilted towards the back, pipes across the front are level with the block
looking at the pictures...i shouldve lined the flex bellow up centered with the crank pulley
that was just where the end of the pipe was o well
looking at the pictures...i shouldve lined the flex bellow up centered with the crank pulley
that was just where the end of the pipe was o well
It’s still a work of art. Nice.i also wanted to have the flange angle slightly up to hold the turbo, but the angle of the pipes just ran it into the ac compressor and crank pulley. and it wouldve made the turbo height a lot higher so its very near level and just slightly tilted towards the back, pipes across the front are level with the block
looking at the pictures...i shouldve lined the flex bellow up centered with the crank pulley
iamdub
Full Access Member
Can't argue. Tyler got dat fiyah!
