Randeez 2012 Budget Yukon Denali Build (stick on hood scoops galore)

[pwtr02ss]

Tough call. I've been going round and round at your pics for 20 minutes.

I think I like #2, although I'm trying to picture a cool routing for a braided hose to the radiator...

I agree. simple

 

[randeez]

This light is badass.
Also really glad I didnt drill a hole in water pump cause driver side steam vent runs into accessory bracket on driver side

Pictures with just light on @7pm

 

[randeez]

yep.

 

[randeez]

Should be able to turn it over today, but wont be running.
Got rest of turbo on, all accessories, belt, wiring, turbo oil feed/drain, downpipe connected to exhaust, engine cross member, sway bar.

I need to rewire the flex fuel sensor and the fuel pressure sensor (now on y fitting). Put in the fans and charge pipes (easy)

 

[Sam Harris]

Should be able to turn it over today, but wont be running.
Got rest of turbo on, all accessories, belt, wiring, turbo oil feed/drain, downpipe connected to exhaust, engine cross member, sway bar.

I need to rewire the flex fuel sensor and the fuel pressure sensor (now on y fitting). Put in the fans and charge pipes (easy)

Looking forward to it!! arty:

 

[randeez]

i was being lazy and hoping someone made some extension harnesses for flex fuel and fuel pressure sensor, but apparently those arent hot ticket items
i need to grab some small wire to make both of those work.

passenger side ignition coils i need to relocate, they wont go back on the valve cover with crankcase vent and crap.

steam vent i have tied together behind the waterpump will prob just change over to a hose barb and run to radiator to not worry about it for now.




done:

i put on one catch can to both valve covers (-10an on both) that is open air, it will act as "supply" for the other catch can that will be a closed can between valley cover and intake with a check valve (-8an the whole way). the closed can has some weird thread, 3/8 npt will thread into it a few threads then jam up. 14mm will thread into it fully but not sure i can find 14mm x 8an fittings. so i will probably run the 3/8npt tap into them a little further and use it - only for pcv not to concerned with perfect seal

charge pipes are done.

driverside ignition coils are on.

vac lines to BOV/wastegate/fuel tank vent

all the other sensors are in

i tried to keep it all neat but theres just so much crap to put on

 

[Rocket Man]

Always so much crap. It’s hard to keep things super neat.

 

[randeez]

I need some real catch cans... these are a couple of cheapy ones off Amazon. I actually knocked the screen/filter out of the fresh air can it took a good amount of effort to blow thru. Just dont really feel like spending 400+ for a pair of mighty mouse or motion raceworks

 

[randeez]

 

[iamdub]

I put one of those on my brother's truck after adding a stainless scrubber pad to it. I took it to Home Depot and found barbed fittings with the oddball port thread size. I don't recall what that size was, though.