Show off your 2015+ leveled Tahoes and Yukons!

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

MidnightZ71

TYF Newbie
Joined
Nov 25, 2018
Posts
4
Reaction score
1
Picked this '19 Z71 up last year, and just got done with the mods below. Fox 2.0's up front and shocks out back. Wayyy better than the stock suspension. Then put 275/70R18 Toyo ATIII's on. Clearance is fantastic up front now, gained nearly 4" total at the bumper. Had to do a little massaging to the front passenger fender liner with a heat gun, but now there is no rubbing at all.

View attachment 268433 View attachment 268434 View attachment 268435
What setting on the fox up front? Looks great!
 

STORMIN08

Full Access Member
Joined
Nov 21, 2011
Posts
974
Reaction score
460
2017, 4wd w/ smooth ride suspension.
2.5 / 1.5 Motofab
Bilstein 5100 rear
Stock front strut (for now)
285/50/22 Toyo AT3

Ride is as expected with a slightly leveled IFS and bilstein 5100....great at normal to high speed, sharp and noticeable at low speed

Also did the Powerstop Z36 brake kit...huge improvement, first trip was 800 plus miles loaded down with a 6K trailer, return was unloaded and driven more sporty...
Brakes performed above expectations.
 

Attachments

  • 20210605_160449.jpg
    20210605_160449.jpg
    509.5 KB · Views: 94
  • 20210607_175856.jpg
    20210607_175856.jpg
    538.5 KB · Views: 97

ItstheHOFF

Full Access Member
Joined
Jul 26, 2019
Posts
105
Reaction score
99
Location
Henderson, NV
2017, 4wd w/ smooth ride suspension.
2.5 / 1.5 Motofab
Bilstein 5100 rear
Stock front strut (for now)
285/50/22 Toyo AT3

Ride is as expected with a slightly leveled IFS and bilstein 5100....great at normal to high speed, sharp and noticeable at low speed

Also did the Powerstop Z36 brake kit...huge improvement, first trip was 800 plus miles loaded down with a 6K trailer, return was unloaded and driven more sporty...
Brakes performed above expectations.
Do you have wheel spacers? And any rubbing?
 

STORMIN08

Full Access Member
Joined
Nov 21, 2011
Posts
974
Reaction score
460
No spacers...the ever so slightest rub on sway bar when holding the wheel cranked.

I could probably shift the sway to center it and have no issues...it only does it on a right turn...cranked hard and holding it.

Normal parking lot turns and driving don't even come close.
 

Bmurray94

TYF Newbie
Joined
Jun 29, 2021
Posts
7
Reaction score
5
Here are some pictures of my 2017 Yukon XL Denali with the following:
- Suspension Maxx 2.5" Front and 1" rear level lift
- Fuel Maverick 20X9 +14 offset wheels
- 305/55/20 Toyo Open Country R/T tires
View attachment 204513
View attachment 204514 View attachment 204512

I am going for this exact look. However my shop can’t source the 305/55/20 at the moment. They do have the 33x12.50s in stock though. It seems it’s about a half inch wider of a tire.

Think I’ll run into any rubbing issues with the same 2.5”F / 1” R level?

20x9 +20 wheel.
 

STORMIN08

Full Access Member
Joined
Nov 21, 2011
Posts
974
Reaction score
460
i would be willing to bet, the 12.5 will rub.

however it will be of the slightest contact at these 2 points...
1. sway bar, generally this is shifted slightly to one side and rubs only at hard lock turns ( i mean holding the wheel tight to the side)
2. the inner fender liners near the front and rear edge ( they have ample room behind them to be pulled back and pinned with a heavy zip tie. ( drill 2 small holes about 1/4" to 1/2" apart, then insert the tie and connect another if needed to reach a stationary item to hold it in place)
 

REF0603

Member
Joined
Jun 10, 2014
Posts
35
Reaction score
46
Location
Montgomery, TX
So guys, I got a really good deal on a trade in and I never got around to installing my katzkin kit on my LS Custom. Apparently, I dont have enough post to post on another section on here. Thats fine. I understand why MODs have rules. Just wanted to let some of yall know incase in might be something some one was interested in.
 

Ray Winkler

TYF Newbie
Joined
Apr 19, 2021
Posts
2
Reaction score
2
2016 Yukon Denali 2wd
Suspensionmaxx 2 inch front lift
Suspensionmaxx 1.5 lift back with 1 inch shock linkage
Stock Rims: 20x9 (picture is after the lift)
Upgraded after lift: 22x9 305/40/R22
IMG_9320.JPG
 

Forum statistics

Threads
132,081
Posts
1,861,985
Members
96,540
Latest member
thewheel82

Latest posts

Top