Stalling while driving.

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

rockola1971

Full Access Member
Joined
Dec 29, 2016
Posts
2,635
Reaction score
3,587
Location
Indiana (formerly IL)
Update;
Test 1- fuel pressure:
With new Guage hooked up, key on, it reads 54 psi, but then it slowly (30-60secs) drops down to 38 and lower. Chilton says it should be between 55 & 62. The tps made a loud click before the pressure started to drop.
Started the engine and the fuel pressure jumped to 55 and held at idle but the needle vibrated the whole time. It was just the engine running I'm sure.
Chilton says if the pressure is low, it's indicative of clogged fuel lines, fuel filter or a faulty pressure regulator, both of which are part of the fuel pump assembly, in the FULL gas tank. I was guessing the regulator or filter when it was stalling out, especially since it started right up again.
Just for grins I'll test the tps. That's what a buddy says it is.
That TPS isnt causing you to have low fuel pressure. Your faulty fuel pump is. "38psi and lower" as you stated aint gonna cut it for a 5.3/6.0....Unless you have a fuel filter on the frame rail drivers side then it could be that. It takes an ungodly amount of debris to plug up the sock at the fuel pump. The old sugar in the tank method sure will do it but natural debris acquired by gas stations likely are never the cause.
 
OP
OP
S

Skunkape

TYF Newbie
Joined
Nov 8, 2018
Posts
7
Reaction score
13
Update 2;
I have been driving all over creation and it has not repeated the stalling issue. The guage has been everywhere, but I haven't let it get below an 1/8 of a tank. Go figure. I'm leaning towards the fuel pump though, because since I've been paying attention to it, it seems it's not as powerful or zippy as usual. Fuel mileage seems to be off also.
I did run some real-time scans and the tps and pedal are communicating with no issues. The left and right bank fuel trims appear to be within desired values, however on the low side (if I'm reading it right) through low rpm ranges on a typical drive.

Thanks for input and I will keep you posted.
 

viven44

Senior Member
Joined
Sep 9, 2024
Posts
133
Reaction score
208
Location
Dallas, TX
If you have a frame mount fuel filter, if it’s clogged it could affect pressure… the clog may be intermittent depending on the particulates and where they are … when you turn off the vehicle any backflow can temporarily unclog .. similar to any filter in oil pickup tubes in engine/trans
 

Forum statistics

Threads
132,707
Posts
1,872,890
Members
97,522
Latest member
onyx24
Top