Tonyrodz's Tahoe Build Thread

[Dantheman1540]

I think the rear was much easier than the front, I did them both no lift.

 

[Tonyrodz]

Does anyone know which bushing goes upper/lower? The wider hole bushing go? Upper being the male. Thx.

 

[Fless]

Does anyone know which bushing goes upper/lower? The wider hole bushing go? Upper being the male. Thx.View attachment 278302 View attachment 278303 View attachment 278304

Like this?

 

[Tonyrodz]

Like this?

View attachment 278309

So the bigger goes on top?
The right? I just want to make sure I don't screw it up and only have to do it once.

 

[Fless]

So the bigger goes on top?View attachment 278310
The right? I just want to make sure I don't screw it up and only have to do it once.

The way I read it, the one that measures 3/4" in diameter goes to the frame bracket. Did you measure the sleeves?

 

[Tonyrodz]

I'm genuinely confused. The OD and length appears the same, only the thickness is different. @Dantheman1540 @Sam Harris @PNW VietVet , have an idea?

 

[Fless]

Appear to be the same, or measure the same? Got a ruler? C'mon, Tony!

From the pics one (on the right) appears to be larger than the other, but we have no measurement to compare.

 

[HiHoeSilver]

@Doubeleive ??

 

[Tonyrodz]

Appear to be the same, or measure the same? Got a ruler? C'mon, Tony!

From the pics one (on the right) appears to be larger than the other, but we have no measurement to compare.

View attachment 278317

Not quite 3/4. But I'll have to assume the bigger sleeve goes on top.

 

[Fless]

That 1" mark is cheating a little, it looks like it's not at the left outer edge of the sleeve. But clearly the top one is about 5/8" diameter and the bottom one is closer to 3/4". Maybe others will confirm.

Can I get a witness?