Tonyrodz's Tahoe Build Thread

[Tonyrodz]

That 1" mark is cheating a little, it looks like it's not at the left outer edge of the sleeve. But clearly the top one is about 5/8" diameter and the bottom one is closer to 3/4". Maybe others will confirm.

Can I get a witness?

It was at the 1", just looks off because of the angle of the dangle.

 

[Fless]

Easier to measure if you set the sleeve on end, on a piece of paper, and trace around it tightly with a sharp pencil. Then measure the inside line diameter on the paper. That removes the dangling angle....

 

[Sam Harris]

All I can say is the bigger one goes on top. I remember when we were assembling these, it was easy to confuse the 2 sizes.

Sorry T. Hope you got them figured out.

 

[Tonyrodz]

All I can say is the bigger one goes on top. I remember when we were assembling these, it was easy to confuse the 2 sizes.

Sorry T. Hope you got them figured out.

That's what I'm leaning to also. Thx @Fless

 

[Doubeleive]

So the bigger goes on top?View attachment 278310
The right? I just want to make sure I don't screw it up and only have to do it once.

yes the bigger one goes up top

 

[Tonyrodz]

yes the bigger one goes up top

Thx Wes--and everyone who chimed in.

 

[randeez]

done yet?

 

[Tonyrodz]

done yet?

I wish. Had to deal with this now--
According wasn't working. Guy grounded out the relay and it kicked on, but not by the head unit. Said most likely the head unit went bad. I hope that's it. Bisch cost me almost $200!
Now my ign cylinder doesn't want to turn.

 

[Sam Harris]

I wish. Had to deal with this now--View attachment 278361
According wasn't working. Guy grounded out the relay and it kicked on, but not by the head unit. Said most likely the human went bad. I hope that's it. Bisch cost me almost $200!
Now my ign cylinder doesn't want to turn.

Wtf..? Wait.. the sway bar install is not done.? What are you trying to do with that hvac control..? You gettin in the sauce early this morning T...?

 

[Tonyrodz]

Wtf..? Wait.. the sway bar install is not done.? What are you trying to do with that hvac control..? You gettin in the sauce early this morning T...?

Seems to be. BS if you ask me!