What did you do to your 2015-2020 K2XX Tahoe/Yukon Today?

[Tonyv__]

Is this on your rear doors? I have it in the same spots on my rear doors.

Ultimately I think the bigger problem is the door alignment which is causing enough contact with the door and the rubber door seal on the bottom to rub the paint off over time.

Yeah. Wasn’t sure if it was common or if I have bigger issues lol

 

[07Burb]

Any of you fine folks need some new rotors for the rear of your rigs??

FS: Power Stop Drilled/Slotted REAR Rotors K2xx

I’ve got a set of PowerStop drilled/slotted rotors for the REAR of a 15-20 (K2xx) Yukon XL, Suburban, ESV. Never installed and still in their bags they came in when I took them out of their box. Never got a chance to install them before my Denali went on to greener pastures. Asking $100 plus...

www.tahoeyukonforum.com

 

[RST Dana]

Any of you fine folks need some new rotors for the rear of your rigs??

FS: Power Stop Drilled/Slotted REAR Rotors K2xx

I’ve got a set of PowerStop drilled/slotted rotors for the REAR of a 15-20 (K2xx) Yukon XL, Suburban, ESV. Never installed and still in their bags they came in when I took them out of their box. Never got a chance to install them before my Denali went on to greener pastures. Asking $100 plus...

www.tahoeyukonforum.com

Price?

 

[07Burb]

Price?

It’s in the link $100 plus shipping

 

[LT1ZOB]

Yeah. Wasn’t sure if it was common or if I have bigger issues lol

This was happening on my 16 rear passenger door. I touched it up, put a piece of xpel over it, and that did the trick.

 

[Thrust]

Added Hellwig rear sway bar end links to my Hotchkis sway bar. Do yourself a favor and ditch the factory end links.
Also bled the Brembo calipers using a snap on diagnosis tool to energize the ABS valves. Seems to have done the trick as the brakes work great.

 

[Sparksalot]

Got some crossbars for the rack. some assembly required.

 

[SpyShops212]

Took it to the dealer in Houston called SeWell Cadillac to have the OEM windshield replaced and the bottom outside trim under the windshield which almost all K2XX trucks get warped. If you anyone goes and check you will see what I am mentioning. I figured it would be the proper time to replace the trim piece while they are at it. I will pick up tomorrow and post to let everyone know how it went. I did make a video and took lots of pictures just in case they mess something up. I also noticed on my previous windshield that there was spots that you could see everywhere when the sun hits it.

 

[Sparksalot]

I found a set of ditch light brackets. No immediate plans for them, but they’re hard to find when you look.

 

[Sparksalot]

Debadged it.