What did you do to your NBS GMT800 Tahoe/Yukon Today?

[Night Fury]

got hoe back from the body shop and mechanic after almost 6 weeks.

Smoked the tailes
installed - slim line in channel window vents 5% tint..

pics!

 

[TheYuk]

installed new factory front parking lights, no more nasty fogged up lens'. tomorrow shes getting a full detail inside and out.

 

[DaRosa218]

Took some nice Pics of the 'Hoe finally...... Can you say new sig Pic?! LOL

 

[Tahoewhat]

I like the new sig, looks cool ride also of course

 

[DaRosa218]

I like the new sig, looks cool ride also of course

Thanks Mike!

 

[Night Fury]

SICK! New sig too.

 

[DaRosa218]

SICK! New sig too.

Thanks Alex

 

[yukon2004]

I finally replaced the motor and regulator for my rear driver's window. Has been stuck a couple of inches down for the past 3 weeks. I don't even know if it was the motor or the regulator that was bad, but I figured if I'm going to tear the door apart, I might as well replace both. Also took off the "window rain guard" thingys. They were on there when I bought it the Yukon, and just never messed with it until today... looks a lot better without them!

With the new motor/regulator half installed:


The old motor/regulator:


---------- Post added at 09:06 PM ---------- Previous post was at 09:03 PM ----------

And yes... that IS a ratchet that I have wedged into the door... I was using it to hold the window up, lol.

 

[MrBalll]

Removed the molding on the driver side. Lot easier than the rear emblems to remove and clean up. Not sure why, but it was. Passenger side tomorrow.

 

[yukon2004]

Removed the molding on the driver side. Lot easier than the rear emblems to remove and clean up. Not sure why, but it was. Passenger side tomorrow.

What all is involved with removing the molding? It's not bolted or screwed in, right? How do you clean it up afterwards/what kind of mess is left behind? Thanks!