What did you do to your NBS GMT800 Tahoe/Yukon Today?

[Rocket Man]

Finally got enough clear weather, and snow melted, to wash and do half a detail today. Ahh.. better. Sorry for the crappy pictures.

Looking good Sam! It’s been raining for a week here with another to go. Nothing but fronts coming in from the Pacific one after another. Mines dirty af.

 

[Sam Harris]

Looking good Sam! It’s been raining for a week here with another to go. Nothing but fronts coming in from the Pacific one after another. Mines dirty af.

Thanks Mark! Yeah, she was a dirty girl for a couple weeks. Hate leaving that crap on her. So nice to get cleaned up!

 

[mwilson62000]

Finally got enough clear weather, and snow melted, to wash and do half a detail today. Ahh.. better. Sorry for the crappy pictures.

I agree. Looking good!

 

[mwilson62000]

PO must have lightly backed into something and broke the end off the bottom step pad. Put a new one on today.
Also had to give it a wash since it was 60 degrees. Finished drying right at dark. No pics.

 

[Mezzo]

Got some new toys coming in the mail,late holiday gift to myself. Been wanthing to do this ever since I had my old suburban.

 

[Rocket Man]

PO must have lightly backed into something and broke the end off the bottom step pad. Put a new one on today. View attachment 266694
Also had to give it a wash since it was 60 degrees. Finished drying right at dark. No pics.

Looks like they didn’t dent the bumper though?

 

[mwilson62000]

Looks like they didn’t dent the bumper though?

Just one kind of “scratch mark” right above where the stepdad ends on the right side. Not noticeable unless your right up on it.

 

[blueinkd]

Installed new inner and outer tie rods and got alignment rechecked at Firestone. Wanted to make sure it was within spec after I messed with keys a bit.

 

[BADRIDES]

PO must have lightly backed into something and broke the end off the bottom step pad. Put a new one on today. View attachment 266694

How difficult was it to change this out? I have a brand new in the box and havent gotten around to changing it out.

 

[mwilson62000]

Honestly, it was a little harder than I anticipated getting the new one snapped in completely. I was able to remove the old one pretty easily, getting a small screwdriver tucked in right beside each tab, then pulling hard with my hands. I found when installing the new one, try to make the tabs come in from above the slot angling down, then most did click in place. The 3rd one from the ends right where the bumper bends in towards the license plate lights were the worse. One I ended up covering with a microfiber towel and hitting with a rubber mallet.