What did you do to your NBS GMT800 Tahoe/Yukon Today?
- Thread starter vwbeaner
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Sam Harris
Supporting Member
Very nice Mark! They look great, as always!
Although.. what’s with the fogged Driver head..? [emoji2959]
Tonyrodz
Resident Resident
They’re both fogged a bit in the lower half. They do that once in awhile depending on temp changes and humidity level but always clear up in a few hours. Anyway, they’re going to be opened up soon to do the quad projector retrofit. I have the second set of projectors and black shrouds all ready to go. There won’t be no stinking chrome reflector bowls in those headlights when I’m done.
Edit: here ya go, all cleared up.
Sam Harris
Supporting Member
Ah, that’s better! Way to go Mark! [emoji16][emoji106][emoji631][emoji631]
Installed a new door latch; the old one is a suspect in my parasitic draw saga. This was the best video:
treehan77
TYF Fiend
Dang, i just cleaned my passenger door latch (front) like a week or two ago and fixed it. Now the rear passenger door one is doing the same thing (doesn't turn on the dome light etc). Just had that panel off to paint the speaker grilles argggh
It takes about 2 minutes to pull a door panel on a NBS, not even any clips to break.
Sam Harris
Supporting Member
This was last week, but anyway.. I had some Lasfit fog bulbs in, and one of them died after only about 2 weeks. Even worse though, these factory fog housings just bounce and wobble all
Over the damn place and it makes me crazy...
So, just to see how this would work.. I zip tied in some small wood blocks, between them and the bumper support, to make them more solid. I know it’s a ricer / ghetto job, but wasn’t sure how they’d work, and the vibration was just too much. They’ve been on for about a week now, and I must say, I’m very happy with the results of my hackery. [emoji23] maybe I’ll pull them out, and paint black at least... I dunno.
Also, pretty happy with these Beamtech 880 fogs so far..
Over the damn place and it makes me crazy...
So, just to see how this would work.. I zip tied in some small wood blocks, between them and the bumper support, to make them more solid. I know it’s a ricer / ghetto job, but wasn’t sure how they’d work, and the vibration was just too much. They’ve been on for about a week now, and I must say, I’m very happy with the results of my hackery. [emoji23] maybe I’ll pull them out, and paint black at least... I dunno.
Also, pretty happy with these Beamtech 880 fogs so far..
This was last week, but anyway.. I had some Lasfit fog bulbs in, and one of them died after only about 2 weeks. Even worse though, these factory fog housings just bounce and wobble all
Over the damn place and it makes me crazy...
So, just to see how this would work.. I zip tied in some small wood blocks, between them and the bumper support, to make them more solid. I know it’s a ricer / ghetto job, but wasn’t sure how they’d work, and the vibration was just too much. They’ve been on for about a week now, and I must say, I’m very happy with the results of my hackery. [emoji23] maybe I’ll pull them out, and paint black at least... I dunno.
Also, pretty happy with these Beamtech 880 fogs so far..
So pretty outside, yet so MacGyver'd underneath all that beauty!
Last edited:
Similar threads
