What did you do to your NBS GMT800 Tahoe/Yukon Today?

[Tonyrodz]

I noticed this while working on it yesterday.
From being lowered I'm assuming. Looks like an old war wound tho. I also noticed RUST!! Above the ds rear wheel well I have some small bubbling happening, and behind the wheel on the lower 1/4 panel the rust bubble has gotten much bigger.
Living in Jersey ain't easy.

 

[Rocket Man]

I noticed this while working on it yesterday.View attachment 452660
From being lowered I'm assuming. Looks like an old war wound tho. I also noticed RUST!! Above the ds rear wheel well I have some small bubbling happening, and behind the wheel on the lower 1/4 panel the rust bubble has gotten much bigger.
Living in Jersey ain't easy.

Looks like somebody put a bolt in backwards. What would happen if you turned it around so the threaded portion is sticking out?

 

[5x10]

Replaced the passenger seat leather
Had some difficulty getting all the wires disconnect from under the seat, to the frame that holds the cushion so I put it on without detaching the cushion all the way, wasn’t too bad

 

[Rocket Man]

Replaced the passenger seat leather
Had some difficulty getting all the wires disconnect from under the seat, to the frame that holds the cushion so I put it on without detaching the cushion all the way, wasn’t too bad

Did you remove the seat from the vehicle like you’re supposed to?

 

[Fless]

Looks like somebody put a bolt in backwards. What would happen if you turned it around so the threaded portion is sticking out?

I agree. That bolt on mine is turned around with the nut on the outside.

 

[Tonyrodz]

Looks like somebody put a bolt in backwards. What would happen if you turned it around so the threaded portion is sticking out?

I agree. That bolt on mine is turned around with the nut on the outside.

Another screw up on the mechanics part i guess. I don't think it could turn it around without running into sn issue. I'll just leave it.

 

[5x10]

Did you remove the seat from the vehicle like you’re supposed to?

Yes I did, would post pics, but they’re too large(got one to work)
Just did the bottom leather,
After removing the seat from the car, drivers seat only had a few disconnects to get the seat from away from the rest of it
The passenger side had multiple wires I couldn’t figure out how to disconnect
But, I had some wiggle room, so I was able to the everything attached