Just Fishing
Can't fix stupid
FedEx says my parts are out for delivery.
fool me once...
I'll believe it when i see it.
fool me once...
I'll believe it when i see it.
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Drok
Full Access Member
yeah they like to tease and get your hopes up often haha
Sam Harris
Supporting Member
It’s a momentous occasion, when I can agree with Brent!
Just Fishing
Can't fix stupid
Just Fishing
Can't fix stupid
Fedex finally came!
w00t w00t w00t
too bad it's really late in the day, lots of yard work done.
Allergy migraine, and i'm covered with dust.
Later task.
Oh and i fixed my second hand engine hoist!
One of the damn legs had a slight bend in it, didn't notice until i had the engine headed out of the tahoe.
Took my HF 20 ton shop press, and a steel plate to spread the pressure across the beam as i took out the bends.
Then followed up with that same plate steel to square the tube up.
Sits real solid now.
Next i'll test it with the old engine block before i call it fixed...
Also look, a splash red!
Got some paint and clearcoat down where the Oring sits for the fill tube, pretty much hoping it will tighten it up and not flake into the oil...
And wind picked up right in the middle of painting these things, so it has a little trash here and there.
Coils will cover this for the most part, so meh.
w00t w00t w00t
too bad it's really late in the day, lots of yard work done.
Allergy migraine, and i'm covered with dust.
Later task.
Oh and i fixed my second hand engine hoist!
One of the damn legs had a slight bend in it, didn't notice until i had the engine headed out of the tahoe.
Took my HF 20 ton shop press, and a steel plate to spread the pressure across the beam as i took out the bends.
Then followed up with that same plate steel to square the tube up.
Sits real solid now.
Next i'll test it with the old engine block before i call it fixed...
Also look, a splash red!
Got some paint and clearcoat down where the Oring sits for the fill tube, pretty much hoping it will tighten it up and not flake into the oil...
And wind picked up right in the middle of painting these things, so it has a little trash here and there.
Coils will cover this for the most part, so meh.
Just Fishing
Can't fix stupid
Mains!
mmmhmm
08z71bgm
Supporting Member
I put the cabin filter kit in today. Man was that evaporator filthy.
Just Fishing
Can't fix stupid
So here i am, rubber gloves on.
Trying to figure where the fk i put the plasti gauge...
Also it's hot in my garage, door closed to keep stuff clean.
Sweat filling up those rubber gloves.
Ewwwww
Trying to figure where the fk i put the plasti gauge...
Also it's hot in my garage, door closed to keep stuff clean.
Sweat filling up those rubber gloves.
Ewwwww
gooffeyguy
Tom
MrCool mini split AC system in the garage FTW!
Sent from my SM-G930V using Tapatalk
Sent from my SM-G930V using Tapatalk
Last edited:
Sparksalot
Supporting Member
LMAO!
