What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
It should be a comedy called “Top Gun?” in which Iceman’s fighter can’t even take off and Maverick ultimately got canned for the fly-by and now plays on the senior beach volleyball tour.
Sent from my iPhone using Tapatalk
all new flinstones on the front, stupid clip was hitting the rotor and squeaking on top of the GT pads I was trying out which are basically racing pads and squeak like hell already, and the GT pads also made excessive dust, so exchanged the rotors and went with some premium ceramic, should be nice and quiet again and little dust.
swathdiver
Full Access Member
Looks good. Mine squeaks backing up.
mine were squeaky most of the time when braking, then a couple days ago it started just being squeaky all the time or when I turned left and would stop when I applied the brakes, so I figured maybe it was the sensor on the pad, I stuck my phone in there a few times and took pictures, the pads looked thin but not that thin so I figured screw it I'll just redo the whole front and that's when I found the bracket tab sitting on the rotor, now I guess I've been driving around for the last 2-3 days with the e-brake on, lol the stupid light is right where I cant see it, luckily I have plenty of cable to adjust so that will be easy.
I had this with my seized guide pin problem. The clip was riding on the rotor all the time and man did it make a terrible noise.
Regency
Supporting Member
- Joined
- Dec 14, 2011
- Posts
- 5,093
- Reaction score
- 664
Detailed her for a bit..
mwilliams
Full Access Member
What size tire are you running? Thank you.
