AtomicHoe094
Atomichoe094
good call. tell me where you run the one wire for ignition
What did you do to your OBS GMT400 Tahoe/Yukon Today?
- Thread starter 96ProCompTahoe
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
SunlitComet
OBS Jedi-Do Good
on the 96 Vortecs there is a fuse that powers the ignition module, coil and two sensors with igntion on. So I will tap into that. At least until I build an "engine running" circuit perhaps.
AtomicHoe094
Atomichoe094
hmm. I need a good place for mine, i ran mine to something under the dash in the meantime and it works but i need a better place
SunlitComet
OBS Jedi-Do Good
How about ecm 1 under the hood?
Last edited:
Who said I didn't notice 'em???? Lmao.....
qukon 95
Full Access Member
- Joined
- Apr 7, 2011
- Posts
- 556
- Reaction score
- 5
getting closer to finishing my new A pillar spkr pods sinse i swapped my dash.
my old pass side pod won't work with this dash.
my old pass side pod won't work with this dash.
retorq
Full Access Member
Finished up the custom shift boot for the Megashifter ...
Installed new interior driver door handle...I was getting tired of rolling down the window to open the door...lol I also started to clean the leather seats. The driver seat is no longer dark, dingy, smooth looking leather...although they will eventually have to be replaced or recovered. The driver seat has a big tear on the side from sliding in/out.
I had the same damn thing...
I found a leather repair kit on Ebay that matched my leather seat cover perfectly....was cheap.... and best of all..... took care of the rip/missing piece in my drivers seat.
Might be a cheap/easy fix for ya'.
