Help Diagnosing Oil leak

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

lspann3525

Full Access Member
Joined
Feb 22, 2023
Posts
119
Reaction score
146
Well im back again with another oil leak after a couple of oil pan gasket changes,rear mail seal replacement and valve cover gasket replacement.

Lately ive noticed my 08 tahoe has been drinking oil so I decided to check the oil pan area and I discovered the front area of the oil pan is covered in oil. I doubt its the oil pan gasket. I replaced it maybe 10 months. Im trying to pin point this im thinking maybe timing cover seal or crankshaft seal??? Anything else in this area that can cause this mess. Heres a video.. any suggestions will help.

 

donjetman

Full Access Member
Joined
Oct 22, 2018
Posts
1,560
Reaction score
2,775
Well im back again with another oil leak after a couple of oil pan gasket changes,rear mail seal replacement and valve cover gasket replacement.

Lately ive noticed my 08 tahoe has been drinking oil so I decided to check the oil pan area and I discovered the front area of the oil pan is covered in oil. I doubt its the oil pan gasket. I replaced it maybe 10 months. Im trying to pin point this im thinking maybe timing cover seal or crankshaft seal??? Anything else in this area that can cause this mess. Heres a video.. any suggestions will help.

Oil consumption:
Install a catch can and have you or a PO installed the improved driver side valve cover per GM TSB# 10-06-01-008M? https://f01.justanswer.com/ebrock63...il+Consumption,+MIL+ON,+Engine+Runs+Rough.pdf

When you had the pan off, I hope you installed a new oil pump to pickup tube o-ring? Also, a dab of rtv is needed where the parting line of the front & rear covers meet the oil pan gasket.

Last summer I changed the timing cover gasket, pulley, seal, o-ring, VLOM, etc, etc, etc:
https://www.tahoeyukonforum.com/threads/valley-cover-crank-pulley-etc.149036/
 
OP
OP
L

lspann3525

Full Access Member
Joined
Feb 22, 2023
Posts
119
Reaction score
146
I havnt installed the updated valve cover yet. I installed new gm pick up tube o-ring and put 4 dabs of rtv where the block meets the covers.

I want to assure its the timing cover gasket sort of hard for me to tell where its coming from. I cleaned that area up during the last oil change so where the leak is coming from its getting worser.

What made you change your timing cover gasket?
 

donjetman

Full Access Member
Joined
Oct 22, 2018
Posts
1,560
Reaction score
2,775
I havnt installed the updated valve cover yet.
In 2018 at 130k miles when we bought our road hard and hungup wet Yukon, the piston rings were stuck from sucking & burning oil because of the the poor original valve cover pcv design. Poor pcv performance/vacuum can cause crankcase gaskets to leak due to too much positive crankcase pressure. Today it has 199k miles and does NOT use any oil.
I installed new gm pick up tube o-ring and put 4 dabs of rtv where the block meets the covers.
thats good
What made you change your timing cover gasket?
It had a small oil leak from ?somewhere? on the front of the engine.
The 2 piece pulley balancer is held together with rubber and we all know rubber doesn't last forever so I changed it and the seal.
 

donjetman

Full Access Member
Joined
Oct 22, 2018
Posts
1,560
Reaction score
2,775
In 2018, when I had the oil pan off, I also installed the afm valve deflector shield GM# 12639759 ($8) per the TSB instructions, even though my engine is NOT afm equipped.
 
OP
OP
L

lspann3525

Full Access Member
Joined
Feb 22, 2023
Posts
119
Reaction score
146
Is there an updated aftermarket driver side valve cover?? I was quoted 146 locally..
 
OP
OP
L

lspann3525

Full Access Member
Joined
Feb 22, 2023
Posts
119
Reaction score
146
Thanks! Thats a pretty good deal. I will consider this for my gen 3 rebuild. Im going to try to find the cheapest driver side valve cover thats updated to see if that slows down the oil consumption. My oil pan /timing cover seems to be leaking. So ill start with the valve cover

Are all the valve covers with the part number 12570427 updated??

Ebay and Amazon are full of 12570427 aftermarkets that are half the price


 
OP
OP
L

lspann3525

Full Access Member
Joined
Feb 22, 2023
Posts
119
Reaction score
146
They all seem to have the rectangle opening instead of the round opening as well.
 

Forum statistics

Threads
132,721
Posts
1,873,165
Members
97,547
Latest member
Fjoel040

Latest posts

Top