Ordered new air dam

[Demer]

I'd love to track down a PPV air dam... I'm too chicken to try and cut my factory one down.

 

[BigBlueLB756]

Old thread, but here's the GM p/n.

http://www.gm-trucks.com/forums/top...ector-installed-on-suburban-gm-part-23365760/

 

[BigBlueLB756]

But then, why spend $200 or so?
Old man laying in the driveway.............



Mark 5 5/8" down from the top of the chin spoiler end and run your masking tape across to that point. Lay another piece of tape above that one to use as a guide and cut between the two. Dremel tool is your friend.

Another "Cheap-@ss" mod!
What's not to love?

 

[pfennig_san]

But then, why spend $200 or so?
Old man laying in the driveway.............



Mark 5 5/8" down from the top of the chin spoiler end and run your masking tape across to that point. Lay another piece of tape above that one to use as a guide and cut between the two. Dremel tool is your friend.

Another "Cheap-@ss" mod!
What's not to love?

I'm preparing to do this mod but first have to fix a corner of the air dam near the wheel that has a broken mount tab from too much curb pounding. I will need to drill a new mount point near it to shore it up. The chin spoiler isn't damaged just the mount tab on deflector. Probably like that when I bought it a couple months ago but can't prove it. I may go higher than you did to take care of the curb surfing problem.

 

[tdriver113]

I went a little bit higher.

 

[AZCreeker]

Old thread, but here's the GM p/n.

http://www.gm-trucks.com/forums/top...ector-installed-on-suburban-gm-part-23365760/

Sweet that's my truck!

 

[pfennig_san]

Took about 2 inches off the bottom. This should cure the curb grinding. Bottom of dam is now 9 inches off the ground.