What did you do to your NBS GMT800 Tahoe/Yukon Today?
- Thread starter vwbeaner
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
No dents in the roof yet?When mine act up I beat on the headliner with my fist until it stops.
mattbta
Full Access Member
Need to do that soon, too. I was programming my Boost Auto fobs and noticed the damned thing making noise.
No dents in the roof yet?
No not that hard lol. I actually only did it once last night. To see if it would knock anything loose that might be stuck in there. So far it's been smooth and quiet though?
Sam Harris
Supporting Member
X2! I’ve been neglecting to do this. Afraid of my headliner.... want to replace it sometime, but not yet.
mwilson62000
Supporting Member
- Joined
- Jan 20, 2015
- Posts
- 426
- Reaction score
- 1,395
not sure on the Tahoe’s, but my Yukon XL has 2 piece headliner and the seam has plugs that pull out and the one piece drops easily about 5 inches from the aspirator. Slide your hand in and swap it out easily.
So a plastic pry tool just can't pop the aspirator out of the headliner?
mwilson62000
Supporting Member
- Joined
- Jan 20, 2015
- Posts
- 426
- Reaction score
- 1,395
^^No. there is a small grill covering it that is snapped into and holds the aspirator in place. The aspirator is too big to fit through the hole. There is one electrical connection into the aspirator above the headliner.
blueinkd
Full Access Member
- Joined
- Nov 21, 2017
- Posts
- 634
- Reaction score
- 1,523
What is this aspirator you speak of??
Nevermind. Just Googled it. I guess only an issue I'd u use the auto temps?? I never have liked using auto temp settings.
Nevermind. Just Googled it. I guess only an issue I'd u use the auto temps?? I never have liked using auto temp settings.
Last edited:
