What did you do to your NBS GMT800 Tahoe/Yukon Today?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Sam Harris

Supporting Member
Joined
Sep 26, 2018
Posts
7,434
Reaction score
14,937
Location
Texas
The crossbar is too short actually. The z71 rails must be slightly closer together. But there is enough meat on the ends that I can slide each of them out ~1/2" reattach them and they would still be quite sturdy. I have not made that modification just yet. Should have tried harder to find a "escalade" set of cross bars. Doh.
I have Esky crossbars I doubt I’ll ever need…
 

Matthew Jeschke

Full Access Member
Joined
Dec 28, 2017
Posts
2,031
Reaction score
1,425
Location
Sahuarita, Arizona
Well, I finally got my rig back from the fabrication shop since I got wrecked and it was totaled a few months back. Now I'm rocking some new custom front and rear bumpers, rock sliders, and a 9500lb winch!

B2YhbE9.jpg


knnTRzv.jpg


T4HSNNG.jpg


ycioNxa.jpg


fAS0EeI.jpg

I googled rock sliders and got a picture of your setup! Dang that's awesome... Do you have some more pictures of how they rigged up mounting locations? On the rock sliders... I see where it mentions were welded to the frame. what points? Any pictures from bottom where stuff mounts up?

I just hit my rear bumper last week off road and thought of all that wasted trim on the rear end that could be cleaned up to improve the departure angle.
 

Forum statistics

Threads
133,354
Posts
1,884,155
Members
98,459
Latest member
Warrior0977
Top