Yeah I figured if this gates gave up too soon and I'm broke I'll just put the oe back on till it fails lol
What did you do to your NBS GMT800 Tahoe/Yukon Today?
- Thread starter vwbeaner
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Bomba02
Full Access Member
- Joined
- Mar 27, 2013
- Posts
- 371
- Reaction score
- 8
Did a quad retrofit to my spec d housing.
Haha is it done now? How's it looking? Where's the pics lol.
Rangel
Full Access Member
NCTyphoonKid
Full Access Member
I washed the 01 it was getting pretty disgusting, the 2000 I haven't really done anything with lately I drive it once a week usually, hoping to get a house with a garage/shop after the new year I would like to get another truck and a decent project vehicle since the Typhoon is literally almost done and I've finally got the interior mostly back together
Bomba02
Full Access Member
- Joined
- Mar 27, 2013
- Posts
- 371
- Reaction score
- 8
Still need to adjust them a bit more got my suspension done setting my ride height then I'll tweak the projectors. I'll snap a pic of the front of the truck tomorrow. My phone really doesn't pick up the light output that good have this semi ok pic while driving and a pic of the driver side light all done.
NCTyphoonKid
Full Access Member
Have you tried replacing the belt? Could be what's chirping
I glad I took a look
Front left wheel bearing.
I been getting an ABS light when I made turns at slow speeds by reading other posting they said this could be caused by a dirty Speed sender so I went out to clean it around 3:30 PM when I found out the wheel bearing was shot.
Ran down to Napa and they were still open got home then found out I needed a 36mm socket Napa was closed by then they close early on Sunday.
Had to run down to Auto Zone and used my rewards points and picked up the socket I needed.
Another simple job turned in to a job that cost more money than planned what new.
Front left wheel bearing.
I been getting an ABS light when I made turns at slow speeds by reading other posting they said this could be caused by a dirty Speed sender so I went out to clean it around 3:30 PM when I found out the wheel bearing was shot.
Ran down to Napa and they were still open got home then found out I needed a 36mm socket Napa was closed by then they close early on Sunday.
Had to run down to Auto Zone and used my rewards points and picked up the socket I needed.
Another simple job turned in to a job that cost more money than planned what new.
Looks great man. Looks so much better without that dang reflector in the high beam spot! Wow I thought my phone was bad with output shots... Yours is terrible lol. In for more pics! How are you liking the extra output?
Similar threads
