What did you do to your NBS GMT800 Tahoe/Yukon Today?

[Rocket Man]

I never see anything with an LS come through the shop needing a starter and the only one I killed had 300k on it. The starter part was fine it was in the solenoid cause it would just click sometimes

I’m only at 170k on my 02 so I guess I won’t worry about it.

 

[Tonyrodz]

I never see anything with an LS come through the shop needing a starter and the only one I killed had 300k on it. The starter part was fine it was in the solenoid cause it would just click sometimes

I’m only at 170k on my 02 so I guess I won’t worry about it.

Just changed mine on my 05 Express, only has 149,000 on it. Fried it! I could smell it when it went.

 

[David Staines]

I dropped in a Sony XAV-AX5000 radio. I had one in my previous Tahoe and really liked it. The second time you do it is WAY easier... especially when you have a heat gun and solder/shrink wrap for the cable adapter. I had the whole thing done in less than an hour. I also found the correct bow-tie for my HD grille. Lastly... I finally had the AC system completely re-done.

 

[Tonyrodz]

I dropped in a Sony XAV-AX5000 radio. I had one in my previous Tahoe and really liked it. The second time you do it is WAY easier... especially when you have a heat gun and solder/shrink wrap for the cable adapter. I had the whole thing done in less than an hour. I also found the correct bow-tie for my HD grille. Lastly... I finally had the AC system completely re-done.

View attachment 261074

View attachment 261075

View attachment 261076

Front end looks good.

 

[HurricaneSSeason]

I did footwell lights they're not as bright as I'd like I've got T10 sockets and T10 LEDs coming and may switch them out

Which wires did you tap into?

 

[Woodblocker55]

2002 Chev suburban LT fixed ground and turned around and seen another to the rear in the rust camo ya battery charger even charged more crazy ...

Sent from my LGL722DL using Tapatalk

 

[druiddonn]

Which wires did you tap into?

I tapped into the fuse box between the brake pedal and emergency brake I can't find the photo of it right now but I simply used a spade and slid it into the connection next to the existing connection I think it was an orange wire and then I grounded it to the bar that's part of the crash that come under the dash

 

[NoReverseYukon]

After much f-ing around, I got those 2-piece dust shields behind the back rotors. Beats pulling the axles, but they're rubbing. I'll drive it around the block to check where, then do some bending.

 

[Sam Harris]

Washed her off after the snow earlier this week. Halfway detailed, cleaned air filter, so had to touch up a little under the hood.

 

[Fless]

Washed her off after the snow earlier this week. Halfway detailed, cleaned air filter, so had to touch up a little under the hood.

I am so shamed when I see this! LOL