I have never had a problem with one.
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
where the bolt goes on it can pivot a little if it moves a little it wont make contact, if you ever loose your brake lights or cruise and the fuse and bulbs are good then check down under the dash and try pivoting the switch up. doesn't matter how tight the bolt is it can still move by hand it doesn't have a notch or ridges just smooth plastic edge on a smooth metal edge.
*when I had my 00 it happened a handful of times over 12 years, I thought the switch had gone bad and went to replace it and discovered it could turn a little, turned it back up and walla, I don't cruise much but whenever someone would say "you have no brake lights" I knew exactly what it was, hasn't happen on the 12 yet but it's the same design.
mikeyss
Full Access Member
I replaced my driver's seat bottom T.E.D. and it wasn't very fun to do, but it wasn't too bad once I unbolted the seat. Now my bun warmer works again, which makes me happy!
Geoffsfas10
Full Access Member
This is going to be a GIANT tease BUT.... i test fit my retrofit headlights......glory was had. Cut off is sharp, blue and purple. Now to finish them.
avalonandl
Full Access Member
Ordered Arnott air shocks for the rears. They are blown...Rock Auto 5% savings....
Wolfbraid
Full Access Member
So Glad, new tires, and TPMS sensors... finally have pressures and the lights are all gone.
yeah yeah.. 40psi warm, don't mention it.
yeah yeah.. 40psi warm, don't mention it.
And a full tank of gas!So Glad, new tires, and TPMS sensors... finally have pressures and the lights are all gone.
yeah yeah.. 40psi warm, don't mention it.
View attachment 240269
Wolfbraid
Full Access Member
I can't get enough e85.... zing! except for road trips when I want better economy.
HiHoeSilver
Away!
Geoffsfas10
Full Access Member
ha..exactly....im waiting til i have everything finished so I can make one thread...or i can make you guys all suffer for the next week or so as I slowly finish them and feed in pictures.
