What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[Geotrash]

Hooked the camper up to it.

 

[89Suburban]

Hooked the camper up to it.

View attachment 397834

Take me!!!!

 

[Geotrash]

Take me!!!!

C'mon down! We have steaks and whisky!

 

[RooTBeeRthe1st]

C'mon down! We have steaks and whisky!

A bit far for me, you might be back home by the time I make it.

 

[CaptainAmerica1]

Installed TPMS sensors so that damn dash light would go off…

 

[StrkAliteN]

Hooked the camper up to it.

View attachment 397834

Very nice !

I finally got my Equalizer weight distribution hitch installed on my Yukon and the 20 foot enclosed cargo trailer last week.
Took it for a test run to see how it handles ( 10 mi round trip ) Trailer was empty, but still 3100 lbs. I was curious to see how the braking - steering and handling was.
And to see how the Tekonsha P3 brake controller worked. Everything performed 100% and I was surprised at the ease of handling even at 63MPH top speed for the test drive.

 

[Doubeleive]

@swathdiver before you have mentioned some return-springs? that go in the calipers to keep the pad off of the rotor? do you have a part number for the front?

 

[Ivanhoe]

Changed front hub assembly..went smoothly until a bolt decided it was happy staying put, it was awkward to get at with my Impact as well.


Managed to get an extension on my Impact which after a few attempts managed to get it moving. Hub came off after a few gentle taps with my fine adjusting tool
Replacement was a mevotech upgraded unit with new bolts and hub nut.

Free shipping within Canada was a bonus. I used Thewrenchmonkey.ca ( for anyone else up north).

It was making grinding noise when i turned it by hand. Other side isn't making noise yet so I'm not changing it. Took a bit longer than expected due to the bolt and searching for.my torque wrench.

 

[RooTBeeRthe1st]

I suppose I should get around to putting these on at some point. I only had them laying around for 2 years.

 

[avalonandl]

Changed front hub assembly..went smoothly until a bolt decided it was happy staying put, it was awkward to get at with my Impact as well.


Managed to get an extension on my Impact which after a few attempts managed to get it moving. Hub came off after a few gentle taps with my fine adjusting tool
Replacement was a mevotech upgraded unit with new bolts and hub nut.
View attachment 397997
Free shipping within Canada was a bonus. I used Thewrenchmonkey.ca ( for anyone else up north).
View attachment 397998
It was making grinding noise when i turned it by hand. Other side isn't making noise yet so I'm not changing it. Took a bit longer than expected due to the bolt and searching for.my torque wrench.

We changed both hubs at buddys shop. I figured once up in the air do both.