where do you get your fogs?

[bottomline2000]

ebay as well. got the smoked version and have 35w 6000K HIDs in them. less than $50/pr. no problems so far

Did you buy the lense cover or the complete foglight. I just ordered the smoked grey lense covers and was wondering if they will hold up to 35w HID. They are acrylic I believe.

 

[polobuds]

complete foglight. ive had no problems with my 35w HID.

 

[ezdaar]

Best Driving light housings out there.

 

[rippinitup]

i got my fogs in the other day from amazon. $36 shipped for a pair. my HIDs wont fit in from the metal thing that goes in front of the bulb. should i push that back some how?

 

[chauncey0337]

i got my fogs in the other day from amazon. $36 shipped for a pair. my HIDs wont fit in from the metal thing that goes in front of the bulb. should i push that back some how?

I just used a flat head screwdriver to push the metal reflector forward. Make sure that the hid bulb doesn't touch the reflector because it will get hot and melt the inside of the housing.

 

[rippinitup]

I just used a flat head screwdriver to push the metal reflector forward. Make sure that the hid bulb doesn't touch the reflector because it will get hot and melt the inside of the housing.

exact answer i was looking for thanks alot!

 

[chauncey0337]

exact answer i was looking for thanks alot!

No prob. Post pics when you're done.

 

[rippinitup]

will do for sure!

 

[polobuds]

i got my fogs in the other day from amazon. $36 shipped for a pair. my HIDs wont fit in from the metal thing that goes in front of the bulb. should i push that back some how?

Yep, do what chauncey said. For some reason the bulbs dont fit and the HID bulb is slightly longer than the stock fog bulb. Just be careful not to push/bend too hard. Move it back enough to fit the bulb. push then fit until just right

 

[Yukon_]

Had that problem too, but used a heat gun to remov the front clear lens, then 'to my surprise' had to pry the aluminum square out of each housing, took some doing. re-sealed the lens to the housings with clear caulk (silcone), then the HID6000K's fit. did not think (at the time) about just pushing them forward a little.