2008 Ford Crown Victoria P71 SAP

[95escahoe]

Needed a cup holder after the console so picked up this it works perfect.



Picked up a rear upper Inner Edge.



Updated interior pic:

 

[95escahoe]

Been debating throwing on Mustang wheels for awhile so around Christmas there was a bunch of sales so snagged these reproduction Bullitt wheels 17x9 up from 17x10.5 in the rear. Going to wait till spring to throw them on.

 

[89Suburban]

Actually a bunch so I got that 3 head upper Inner Edge installed.


View attachment 389845
View attachment 389846
View attachment 389848View attachment 389847

Then I finally installed that console I got a few months back and switched out the siren controller and light switches for one unit a Touchmaster Delta, all the lights are are on the slide switch everything comes on on the last setting and all the buttons are available for more lights down the road possibly.

View attachment 389849

Very nice!

 

[89Suburban]

Needed a cup holder after the console so picked up this it works perfect.

View attachment 389850

Picked up a rear upper Inner Edge.

View attachment 389851
View attachment 389852
Updated interior pic:
View attachment 389853

Those bolts in the roof how was that construed? Are there factory inserts?

 

[95escahoe]

Those bolts in the roof how was that construed? Are there factory inserts?

So there’s two push in clips that hold the headliner up in the rear so you pop those out and drill out the hole and make it bigger then you pop in a jam nut in either hole there’s a special tool they make to install it, it’s basically a flat piece of metal with a hole in it you put the bolt through then put it in the hole and tighten it down which causes the back side to crush to the back side of the roof and gives the bolt a nice sturdy mounting point.

 

[Tonyrodz]

Actually a bunch so I got that 3 head upper Inner Edge installed.


View attachment 389845
View attachment 389846
View attachment 389848View attachment 389847

Then I finally installed that console I got a few months back and switched out the siren controller and light switches for one unit a Touchmaster Delta, all the lights are are on the slide switch everything comes on on the last setting and all the buttons are available for more lights down the road possibly.

View attachment 389849

I see you have the built in fire suppression system. Pretty cool. Is it still hooked up?
I've also been looking for some used Mustang rims, but haven't had any luck.

 

[95escahoe]

I see you have the built in fire suppression system. Pretty cool. Is it still hooked up?
I've also been looking for some used Mustang rims, but haven't had any luck.

It was till I threw the cat-back on the bigger exhaust wouldn’t clear the tanks so had to remove them, been trying to sell the complete system but nobody wants it I was looking for used wheels for awhile but they pretty much all needed tires or the rims had issues so just bit the bullet and bought new ones

 

[95escahoe]

I really wanted 07-14 GT500 wheels but couldn’t really find much at the time used for a good price.

 

[Tonyrodz]

It was till I threw the cat-back on the bigger exhaust wouldn’t clear the tanks so had to remove them, been trying to sell the complete system but nobody wants it I was looking for used wheels for awhile but they pretty much all needed tires or the rims had issues so just bit the bullet and bought new ones

The tanks are mounted under the car? I thought they were mounted in the trunk.

 

[95escahoe]

The tanks are mounted under the car? I thought they were mounted in the trunk.

Ya underneath there mounted near the rear end the electronics for it are under the rear sear, and the seats for the FSS cars are molded to fit over it