What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[Jason in DLH]

But you really should want one.

What made you decide to remove the sway bar? I consider it a safety thing myself.

I’m gearing up to transform it to an off road machine. My wife won’t let me get a Wrangler, so I’m going to play with this.

 

[Sparksalot]

Did you try jumping the pins and see if the starter works? also reach under there and smack it with a hammer a couple times that may get you going

Which pins? I haven't found a good schematic of the starting circuits.

 

[Doubeleive]

Which pins? I haven't found a good schematic of the starting circuits.

pull the starter relay and then short pin 30 & 87 with a wire all gm relays are the same (4 pin)

 

[wsteele]

pull the starter relay and then short pin 30 & 87 with a wire all gm relays are the same (4 pin)

Beat me to it.

Here is one that can help you when you want to swap things to eliminate bad relays, etc.

 

[wsteele]

I’m gearing up to transform it to an off road machine. My wife won’t let me get a Wrangler, so I’m going to play with this.

I wonder if anyone makes an aftermarket hydraulic sway bar disconnect for these trucks? Nah...

 

[avalonandl]

That front sway bar helps in handing on hard corners. You won't really notice it otherwise. Mine was not connected b/c the links rusted to nuthin...we repllaced them and I like the way it drives better....

 

[Sparksalot]

Well, my Tech2 has shipped.

 

[Sparksalot]

Beat me to it.

Here is one that can help you when you want to swap things to eliminate bad relays, etc.

I actually have an extra, fully populated fuse panel. Only the reverse relay is inop. Of course that one is hardwired.
I was able to try a few different relays to make sure the in use ones were okay.

 

[Sparksalot]

pull the starter relay and then short pin 30 & 87 with a wire all gm relays are the same (4 pin)

That's handy. I'll try that later today.

 

[wsteele]

Well, my Tech2 has shipped.

Too funny, I bought one Ebay yesterday.