We got the old one out and the transfer case as well. Problem is we're not sure what's the best way to go about putting it all back together. I've never had to mess with a 4wd and all so I was hoping someone has done this before. When we took the tranny and transfer case out we had it angled as much as we could as we lowered both the tranny and transfer case at the same time. Obviously there isn't enough room to just bolt them together and jack them up at the same time so I'm not sure what to do. I think we're just gonna put the tranny in, and then hope we can maneuver the transfer case in there to fit and line it up to bolt in.
Anyone got any ideas? Thank you very much in advance!
Anyone got any ideas? Thank you very much in advance!